Hewlett Packard Enterprise Company ARUBA52 ユーザーズマニュアル
7/29/03 FINAL DRAFT—CONFIDENTIAL
18
Aruba 52
Part 0500007B
Installation Guide
August 2003
Mount the Aruba 52
When initial setup is complete, mount the Aruba 52 in its intended service location.
Select a location as close as possible to the center of the intended coverage area. If necessary,
use the Aruba WLAN Switch’s built-in site survey software to determine the optimum loca-
tions for your access points and air monitors (see your Aruba AirOS Software Guide).
use the Aruba WLAN Switch’s built-in site survey software to determine the optimum loca-
tions for your access points and air monitors (see your Aruba AirOS Software Guide).
The service location should be free from obstructions or obvious sources of interference. Nor-
mally, the higher you place an access point or air monitor, the better its performance.
mally, the higher you place an access point or air monitor, the better its performance.
The Aruba 52 can be mounted in the following ways:
F
IGURE
2-2 Aruba 52 Mounting Options
Flat on a table or shelf (with the LEDs on top)
Upright on a wall (with the port connectors on top) using the built-in mounting slots
or the optional mounting kit
or the optional mounting kit
Suspended from above (with the LEDs on bottom) using the optional mounting kit
1
2
3
READY
LAN
.A
.B
R
E
A
D
L
A
N
.A
.B
READY
LAN
.A
.B
1
2
3
C
AUTION
—
For safety purposes, do not mount the Aruba 52 sideways (with the air
vents on top and bottom).