Hewlett Packard Enterprise Company ARUBA52 ユーザーズマニュアル
Setup & Installation
17
Chapter 2
7/29/03 FINAL DRAFT—CONFIDENTIAL
summarizes the server environment variables discussed above.
Specify an IP address, if necessary.
If using DHCP, the Aruba 52 will obtain its IP address automatically and this step can be
skipped. Otherwise, the AP must be manually configured with a static IP address using the fol-
lowing commands:
skipped. Otherwise, the AP must be manually configured with a static IP address using the fol-
lowing commands:
Save the configuration and reboot the Aruba 52.
Once the Aruba 52 boots, disconnect it and mount it in its intended service location (see
instructions on
instructions on
).
T
ABLE
2-2 Server Enviornment Variable
Variable Name
Default Value
Use
Comments
servername
aruba-master
DNS name of the
master M-switch.
master M-switch.
Also serves as the
TFTP servername if
serverip
TFTP servername if
serverip
is not set.
serverip
n/a
IP address of the
TFTP server.
TFTP server.
Overides servername
for TFTP image
download. Use only
if DNS is unavail-
able or must be
bypassed.
for TFTP image
download. Use only
if DNS is unavail-
able or must be
bypassed.
master
n/a
IP address of the
master M-switch.
master M-switch.
Overides servername.
Use if DNS is
unavailable or must
be bypassed.
Use if DNS is
unavailable or must
be bypassed.
apboot> setenv ipaddr
<static IP address for the AP>
apboot> setenv netmask
<static IP address mask>
apboot> setenv gatewayip
<default gateway IP address>
apboot> save
apboot> boot
3
4