Tagsys S.A. LSP3CLEAR-L40 ユーザーズマニュアル
18/68
Revision 2.1
December 2009
The components of the L-SP3 EAS system are contained within the L-SP3 pedestal. At
least two pedestals are required for each EAS gate. A set of pedestals is known as a gate and may
consist of several pedestals. Please see section 4
consist of several pedestals. Please see section 4
“Installation
” for more information.
The L-SP3 is built in a one frame:
An L-SP3 Electronics unit is used to control each pedestal. This electronics unit
generates the RF signal transmitted by the antennas and picks up the reply from the
RFID tag. If an activated RFID tag is detected, the electronics unit will activate the
LED/buzzer alarm
RFID tag. If an activated RFID tag is detected, the electronics unit will activate the
LED/buzzer alarm
These antennas are sensitive receivers used to detect the theft bit status and the AFI
value of the RFID tag as it passes through the EAS gate
Visual and audible warning devices
A remotely accessible people counter equipped with dual light barrier photoelectric
sensors.
To operate, the L-SP3 will only need an IEC power supply cable, avoiding unnecessary mains
cable wiring up.
cable wiring up.
An IEC Mains Supply Cord Outlet is available to allow daisy chaining. A series of up to 5 pedestals
can be powered up from a single wall socket.
can be powered up from a single wall socket.