Tagsys S.A. MEDIOP101ETHER ユーザーズマニュアル
Installing the Reader
April 2008
Revision 2.2
17/41
• Ethernet module connector
A shielded RJ 45 connector (Please refer to the Ethernet network cabling rules)
• Power supply connector J2
2.5mm Jack type (positive connection on the center pin)
• Reset button
Reset button only used for Ethernet module (Please see
Chapter 4.2
for more details)
• USB connector
USB connector type B
When USB communication link is active (plugged and powered), the Ethernet module is
turned off.
turned off.
4.2 Communicate with Ethernet Interface
Preliminary checking:
-
USB cable must be unplugged to ensure that the Ethernet Module is turned on
-
Shielded
ethernet cable must be correctly connected to the rear panel
The embedded Ethernet module is the DigiConnect -ME. Any information on this module is
available on the CDROM in the directory “\DigiConnect IntegrationKit\Documentation” or on the
DigiConnect WEB pages at “
available on the CDROM in the directory “\DigiConnect IntegrationKit\Documentation” or on the
DigiConnect WEB pages at “
www.digi.com
”.
Please read the DigiConnect User’s Guide to have an overview of the module characteristics.
The following explanations will give you the first steps to run the reader. Advanced functionalities
can be found in the DigiConnect User’s Guide.
The following explanations will give you the first steps to run the reader. Advanced functionalities
can be found in the DigiConnect User’s Guide.