Tagsys S.A. RXU500 ユーザーズマニュアル
Speedway Revolution Installation and Operations Guide
14
Copyright © 2009, Impinj, Inc.
This section explains how to use MultiReader to connect to and configure a reader’s RF
parameters. It also provides a high level description of each parameter.
parameters. It also provides a high level description of each parameter.
To configure and test a reader from within MultiReader:
1. Install and launch the MultiReader application. The following screen appears:
2. Click Configure Settings. The Reader Settings screen appears:
3. Connect to the reader by doing the following:
•
In Name or IP Address, type the reader’s IP address (or host name). You can
determine the name and the IP address via the Rshell
determine the name and the IP address via the Rshell
show network summary
command.
Note:
The
show network summary
command will provide the dynamic values returned by
DHCP or LLA if the current configuration is dynamic. The local hostname resolution fea-
ture (mDNS) gives the reader a local hostname in addition to an IP address as its network
ture (mDNS) gives the reader a local hostname in addition to an IP address as its network