Gemalto M2M GmbH EMS31-VR1 ユーザーズマニュアル
Cinterion
®
EMS31-V Hardware Interface Overview
5.4 Compliance with FCC and Regulations
27
EMS31_V_HIO_v00.004
2018-02-27
Confidential / Preliminary
Page 26 of 35
5.4
Compliance with FCC and Regulations
The Equipment Authorization Certification for the Gemalto M2M reference application de-
scribed in
scribed in
will be registered under the following identifiers:
•
EMS31-V:
FCC Identifier: QIPEMS31-V
R1
Manufacturers of mobile or fixed devices incorporating EMS31-V modules are authorized to
use the FCC Grants of the EMS31-V modules for their own final products according to the con-
ditions referenced in these documents. In this case, an FCC label of the module shall be visible
from the outside, or the host device shall bear a second label stating "Contains FCC ID:
QIPEMS31-V
use the FCC Grants of the EMS31-V modules for their own final products according to the con-
ditions referenced in these documents. In this case, an FCC label of the module shall be visible
from the outside, or the host device shall bear a second label stating "Contains FCC ID:
QIPEMS31-V
R1". The integration is limited to fixed or mobile categorized host devices, where
a separation distance between the antenna and any person of min. 20cm can be assured
during normal operating conditions.
during normal operating conditions.
For mobile and fixed operation configurations the antenna gain, including cable loss, must not
exceed the limits in the following
exceed the limits in the following
for FCC.
IMPORTANT:
Manufacturers of portable applications incorporating EMS31-V modules are required to have
their final product certified and apply for their own FCC Grant related to the specific portable
mobile. This is mandatory to meet the SAR requirements for portable mobiles (see
Manufacturers of portable applications incorporating EMS31-V modules are required to have
their final product certified and apply for their own FCC Grant related to the specific portable
mobile. This is mandatory to meet the SAR requirements for portable mobiles (see
for detail).
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
could void the user's authority to operate the equipment.
Note: Manufacturers/OEM Integrators must ensure that the final user documentation does not
contain any information on how to install or remove the module from the final product.
contain any information on how to install or remove the module from the final product.
Table 13:
Antenna gain limits for FCC
Operating band
FCC limit
Unit
Maximum gain in lower operating bands with f< 1GHz
(LTE Bd13)
8.41
dBi
Maximum gain in higher operating bands with f=1700MHz
(LTE Bd4)
4.5
dBi