Vivato Inc. VLJ24WFSW ユーザーズマニュアル
Vivato 2.4 GHz Wi-Fi Switch User Guide
149
Command Line Interface
Enable Level Command Descriptions
edit flash:
After entering this command, you are prompted to enter the name of a configuration file in the Wi-Fi
Switch to edit. The CLI then launches a vi editor to allow the configuration file to be modified and
saved. CLI operation returns after exiting the vi editor.
Switch to edit. The CLI then launches a vi editor to allow the configuration file to be modified and
saved. CLI operation returns after exiting the vi editor.
To exit the editor without saving your changes, type :q!. To save your changes and exit, type
ZZ
or
:wq
.
exit
After using the
command to configure the Wi-Fi Switch, the CLI stays in the
configuration mode until you enter the
exit
command. If you exit the configuration mode and enter
the
exit
command again, the current CLI session is closed.
no <configuration command>
Override parameters you have entered. This operation is used extensively in the enable level
commands to disable previously enabled operations or settings (as shown in this command list).
commands to disable previously enabled operations or settings (as shown in this command list).
reboot
Issuing this command causes the Wi-Fi Switch to be reset, and powers on using the last saved
configuration. See
configuration. See
on page 118 for commands to save
the current configuration.
CAUTION —
Any changes made to the configuration that have not been saved are lost when this
command is issued.