Vivato Inc. VLJ24WFSW ユーザーズマニュアル

The Vivato Wi-Fi Switch can be quickly configured using its built-in web page. Using the 
factory-supplied RJ-45 crossover cable and a computer with a network interface card that is set up for 
TCP/IP communication, you can quickly connect the Wi-Fi Switch to the computer and display the web 
pages to start configuration. If your computer has an IEEE 802.11b wireless client interface card 
installed and configured, you can access the configuration web page over the wireless connection.

The web interface does not support all configurable settings at this time. Use the 

 (CLI) to make additional configuration changes.

The CLI is accessed through the RS-232 port using a terminal program or by using a secure shell 
program connected through an Ethernet connection. This is provided for users who are experienced at 
using a CLI. See 

on page 97.

Connect a computer to the Wi-Fi Switch and access the Vivato Vision web pages. See 

Enter the initial configuration information on the Quick Setup pages. See 

Reboot the Wi-Fi Switch. The settings on the Quick Setup pages do not take effect until 

after the Wi-Fi Switch has been rebooted. 

Using the IP address and Read password that you specified during the Quick Setup, 

access the Vivato Vision web pages again.

 Click on “Enable Mode” (upper right corner) and enter the Enable password you 

entered during the Quick Setup.

Edit the security settings as needed to secure your network. See 

on page 67. 

Review the 

 information to see if there are other changes that 

need to be made to the configuration that are not part of the Quick Setup settings.

Connect a cable from your LAN to the Wi-Fi Switch’s LAN port. See 

With your 802.11b clients properly configured, you should now have secure Wi-Fi 

operation between your clients and your LAN. See 

page 151 to see how you can make sure that everything is working as expected.

Security settings are initially disabled to allow your computer to access the web pages 
and configure the Wi-Fi Switch. To ensure Wi-Fi security before putting the switch 
into service, make the necessary changes to the security settings during the initial 
configuration. See 

on page 67.