Vivato Inc. VLJ24WFSW ユーザーズマニュアル
Vivato 2.4 GHz Wi-Fi Switch User Guide
59
Network Configuration Web Pages
Network Settings
Configuring the Wireless Interfaces as a Group
The following settings are available when you choose to configure the wireless interfaces
as a group:
as a group:
•
ESSID: The extended service set identifier is the name that the wireless interface
uses to identify itself, and should usually be configured to the same value for all
wireless interfaces. This is the name you see when your client lists available wireless
networks. This is NOT the same as the host name; the identifier for the Wi-Fi Switch
that is used in your wired network.
wireless interfaces. This is the name you see when your client lists available wireless
networks. This is NOT the same as the host name; the identifier for the Wi-Fi Switch
that is used in your wired network.
•
State: Enable or Disable the interface.
•
Channel: This is the channel number to use for that interface. For two channel
operation, channels 1 and 11 should be used to prevent overlapping channels.
Corresponding wireless interfaces are automatically “mirrored” when the channel
for any wireless interface (other than 13) is changed. Refer to
Corresponding wireless interfaces are automatically “mirrored” when the channel
for any wireless interface (other than 13) is changed. Refer to
Figure 32—
Editing Wireless Interface Settings as a Group
Use the following steps to change a setting for one or more wireless interfaces.
1
Enter the changes for the ESSID, State, and Channel.
2
Click on the Select for Changes box for the interface(s) to configure using these changes.
3
Select Make Changes.