Vivato Inc. VLJ24WFSW ユーザーズマニュアル

IP Address: Enter the IP address of the bridge.

Netmask: Enter the subnet mask for the bridge.

Mark for Removal Device: Click in the box corresponding to any interface that you 
want to remove from this bridge. 

Make Changes: Configuration changes are not put into effect until you select this 
button.

You can create a new bridge, or add interfaces to an existing bridge, by selecting Create Bridges 
from the Network>Summary page. 

To create a new bridge, enter the New Bridge ID value and select the desired interfaces to include 
on that bridge. To add an interface to an existing bridge, select the Existing Bridge ID and the 
desired interface(s) to add. To select more than one interface at a time, hold down the Ctrl key 
while selecting the interfaces. Select Create/Add to Bridge to put the changes into effect.

The IP address of the default bridge (br0) is used to access the Wi-Fi Switch for initial 
configuration. If you delete this bridge before assigning an IP address to a different 
bridge, VLAN, or Ethernet interface, you will lose connection to the Wi-Fi Switch 
when the bridge is deleted and you will not be able to re-access the configuration web 
pages. In this case you have to configure the Wi-Fi Switch using the command line 
interface (CLI) through the Switch’s RS-232 serial port to assign an accessible IP 
address.

Important An interface can only be used on one bridge; it cannot be “shared” by another bridge. 

Therefore, any interfaces that are already assigned to an existing bridge are not displayed 
when you try to create a new bridge. Since the default bridge, br0, includes all of the 
interfaces, you must delete two or more interfaces from the default bridge before another 
bridge can be created.