JADAK a business unit of Novanta Corporation MERCURY4 ユーザーズマニュアル
42
RFID Protocol Settings
The RFID protocol settings take effect immediately on the reader upon saving them. A restart is
not required. The Default RQL Query runs continuously at startup and thus a change to this
setting requires a restart of the reader.
not required. The Default RQL Query runs continuously at startup and thus a change to this
setting requires a restart of the reader.
RFID Protocol Settings
Setting
Description
UHF Power (dBm)
This field contains the UHF Output power measured in dBm. This setting must
be adjusted carefully to comply with FCC regulations. See the section
be adjusted carefully to comply with FCC regulations. See the section
EPC1 Tag ID
Length
Length
These radio buttons enable combined 96- and 64-bit tag support or single tag
id lengths. If the reader will only be reading 96- or 64-bit tags, select the 96-bit
or 64-bit radio button to optimize read rates.
id lengths. If the reader will only be reading 96- or 64-bit tags, select the 96-bit
or 64-bit radio button to optimize read rates.
EPC0 Search Depth
This field contains the maximum number of EPC0 tags to be singulated on each query.
Gen2 Init Q
This field contains the initial value of
Q
when a search on a
GEN2
target
begins for the first time.
Gen2 DRM On
This field controls whether the Dense Reader Mode (DRM) is on or off when
performing Generation 2 searches.
performing Generation 2 searches.
Default RQL Query
This field contains the initial query that is run continuously when reader starts
up.
up.