Futurecom Systems Group ULC. CMDUHF ユーザーズマニュアル

                                                                                9                                                  

Futurecom 6A074X01 Programming Software must be installed on a personal computer which will be
used for the Channel Module field system installation.  The personal computer must run under MS-DOS
operating system.  Software must be installed only once before the first Channel Module installation.

The following steps must be performed for the Futurecom Channel Module Programming Software
installation:

1.  Select the hard disk drive where software will reside, e.g. drive C:  Determine 3.5 inch floppy

diskette on your personal computer, e.g. A:.

 

2.  Switch to root directory by typing CD\<Enter>.

 

3.  Create FUTURCOM subdirectory by typing MD FUTURCOM<Enter>.

 

4.  Switch to FUTURCOM directory by typing CD FUTURCOM<Enter>.

 

5.  Insert the Futurecom Channel Module Programming Software disk into proper floppy drive,

e.g. drive A.  Type COPY A:*.*<Enter>.  This step copies software into this directory.

The Channel Module must be set up in the following way before field system installation:

1.  The Channel Module must be plugged into the Futurecom subrack and supplied with proper

DC power supply for all set up procedures.

 

2.  Connect the Uplink and Downlink antennas to the Uplink and Downlink Antenna Ports.

 

3.  Turn on the DC power supply.

The procedure to set up the mode of operation for the Channel Module is as follows: