Invensys Rail Corporation 9710-PS009900 ユーザーズマニュアル
iii
COM-00-09-08 REVISION A
FCC RULES COMPLIANCE
The equipment covered in this manual has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at
his own expense.
interference to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference at
his own expense.
FCC PART 90 AND PART 101 REQUIREMENTS
This device contains a radio transceiver which operates under Parts 90.210 and 101.101 of the FCC
rules in a licensed part of the radio spectrum. It is the user's responsibility to obtain required
licensing and authorization to operate this device. Qualified personnel must perform service or
repairs to the radio portion of this device. Any unauthorized modification to the radio module,
shielding, or antenna system may void the user's authority to operate this device.
licensing and authorization to operate this device. Qualified personnel must perform service or
repairs to the radio portion of this device. Any unauthorized modification to the radio module,
shielding, or antenna system may void the user's authority to operate this device.
RF EXPOSURE WARNING
All antenna installation and servicing is to be performed by qualified technical personnel only.
When servicing or working at distances closer than 10 feet (3.05 meters), ensure the transmitter
has been disabled. Depending upon the application and the gain of the antenna, the total
composite power could exceed 200 watts EIRP. The antenna location should be such that only
qualified technical personnel can access it, and under normal operating conditions no other
person can come in contact or approach within 10 feet (3.05 meters) of the antenna.
When servicing or working at distances closer than 10 feet (3.05 meters), ensure the transmitter
has been disabled. Depending upon the application and the gain of the antenna, the total
composite power could exceed 200 watts EIRP. The antenna location should be such that only
qualified technical personnel can access it, and under normal operating conditions no other
person can come in contact or approach within 10 feet (3.05 meters) of the antenna.
This device complies with the following RF energy exposure standards and guidelines:
•
United States Federal Communications Commission, 47 CFR part 2 sub-part J
•
American National Standards Institute (ANSI)/Institute of Electrical and Electronic Engineers (IEEE)
C95. 1-1992
•
Institute of Electrical and Electronic Engineers (IEEE) C95.1-1999 Edition
•
International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998
•
Ministry of Health (Canada) Safety Code 6. Limits Human Exposure to Radiofrequency
Electromagnetic Fields in the Frequency Range from 3 kHz to 300 GHz, 1999
•
Australian Communications Authority Radiocommunications (Electromagnetic Radiation - Human
Exposure) Standard, 2003
•
ANATEL, Brasil Regulatory Authority, Resolution 256 (April 11, 2001)