IP Mobilenet LLC B64450G25 ユーザーズマニュアル

 

 
 

637246.DOC  

Page 

10

 

Preliminary Test Procedure 
 
Perform the following initial setup to prepare the base station for preliminary test: 
 
Step 1 

Connect the antenna to the base station’s TX port. 

 
Step 2 

Connect the base station to the 13.8 VDC power supply. 

 
Step 3 

Power on the base station and verify that the LED’s illuminate and the power LED on the 
front panel remains illuminated. 

 
Step 4 

Verify that the base station DC-supply current is <1.2 Amps. 

 
Step 5 

For the ideal Serial or Ethernet setup please refer to the IPTurbo Converter Reference 
Manual (IPMN p/n: 516.80496.REF) available on the Product Documentation CD 
enclosed with this product. 

 
Step 6 

Connect the antenna to the mobile radio. 

 
Step 7 

Power on the mobile radio. 

 
Step 8 

Recycle the base station power.  

 
Step 9 

Connect the antennae to the base station’s RX1. 

 
Step 10 

Verify that the RX1 and CD LED’s are illuminated when the mobile radio is attempting to 
connect.  Repeat steps 9 and 10 with RX2 and RX3. 

 
Step 11 

From the mobile PC, open the DOS prompt, then ping the IPNC with the following 
command: 

 
 

ping 172.16.23.200 (replacing with the appropriate IPNC IP address).  

 
 Press 

[ENTER] and verify that the IPNC responds to the ping request.  Also verify that 

the base station carrier detect (CD) LED is lit followed by the TX LED.