IP Mobilenet LLC B64450G25 ユーザーズマニュアル
SECTION 3: PRODUCT SETUP AND PRELIMINARY TESTING
637246.DOC
Page
9
Preliminary Testing
This section provides a functional preliminary test for the base station prior to installation. It is used to
determine the condition of the new base station prior to placing into service. If the base station is non-
functional after completing this test, refer to Chapter 6: Customer Support.
This section provides a functional preliminary test for the base station prior to installation. It is used to
determine the condition of the new base station prior to placing into service. If the base station is non-
functional after completing this test, refer to Chapter 6: Customer Support.
This section applies to all base station frequency ranges.
Checklist of Required Material
The following checklist provides a list of tools required to perform this preliminary test procedure.
TABLE 4: CHECKLIST OF REQUIRED EQUIPMENT FOR PRELIMINARY TESTING OF A BASE
STATION
1
Calibrated Base Station System – Consisting of the following components:
(1) Frequency appropriate IPSeries Base Station
(2) Desktop or laptop configured as an Internet Protocol Network Controller (IPNC)
(3) Corresponding IPSeries Mobile Radio tuned to Base Station frequencies (i.e.: if an
(1) Frequency appropriate IPSeries Base Station
(2) Desktop or laptop configured as an Internet Protocol Network Controller (IPNC)
(3) Corresponding IPSeries Mobile Radio tuned to Base Station frequencies (i.e.: if an
IPB138 base, use IP138 mobile)
(4) Desktop or laptop with two (2) available serial ports with Microsoft Windows 98 or
higher, IPMobileNet Dial-Up Networking, IPMessage software, and HyperTerminal for
base station installed
base station installed
(5) Base Station power cable
2
DC power supply with ammeter, with the appropriate volts, see page 7 Current Consumption
for each base station (Astron VS12M or equivalent)
for each base station (Astron VS12M or equivalent)
3
Six (6) antennae (generic mag mounts) tuned to frequency of transceiver
Serial Base Station Interface
No. Requirement 9
1
DB9 RS232 serial cable
2
IPTurbo Converter (IPMN p/n: 900.00012.01)
3
IPTurbo Converter Reference Manual (IPMN p/n: 516.80496.REF)
Ethernet Base Stations Interface
No. Requirement 9
1
Ethernet RJ45 Cable
2
Ethernet Cable