Bendix Commercial Vehicle Systems LLC TX433TS-2 ユーザーズマニュアル
SmarTire Systems Inc.
Tire Monitoring System Reference Manual
6/13/2000 Page 31 of 55
This manual is under review by SmarTire – DO NOT ISSUE
Tire Rotation
After a tire rotation the receiver needs to be reconfigured to accept
existing tire ID numbers from the new locations. The color code on
the transmitter and valve correspond to a sensor number.
To choose this mode press the TIRE button when the tire
rotation icon is displayed
The tire outline indicates the installed sensors. The selected
tire location is filled-in. Use the TIRE button to scroll to the
desired tire location.
rotation icon is displayed
The tire outline indicates the installed sensors. The selected
tire location is filled-in. Use the TIRE button to scroll to the
desired tire location.
Press the MODE button to select it for editing. A number
representing each sensor is shown (e.g. a 2 corresponds to
sensor #2). Press the TIRE or MODE button to increase or
decrease the value respectively.
representing each sensor is shown (e.g. a 2 corresponds to
sensor #2). Press the TIRE or MODE button to increase or
decrease the value respectively.
Press the SET button when the number representing the
desired sensor is achieved. This returns the display to the tire
selection menu. Scroll to a different tire location and edit the
sensor numbers. When all the changes are done, press the
SET button to save and exit this mode.
desired sensor is achieved. This returns the display to the tire
selection menu. Scroll to a different tire location and edit the
sensor numbers. When all the changes are done, press the
SET button to save and exit this mode.
(ID 1 programmed in two
locations)
If more than one tire location contain the same sensor number,
the display will prompt an error with the conflicting tires
filled in and the associated sensor number.
Press SET to return the tire selection menu and make
necessary corrections.
the display will prompt an error with the conflicting tires
filled in and the associated sensor number.
Press SET to return the tire selection menu and make
necessary corrections.
NOTE:
After removing a sensor from the system using the Learn mode (see Diagnostic Modes below),
the sensor numbers may be changed.