Cameo Communications Inc DSLR2001N ユーザーズマニュアル
Setup
TRENDnet
DSLR-2001N
36
As system default route — Check this box to set the current
setting as the default route.
setting as the default route.
ICMP Reply Enable — Check this box to enable ICMP (Internet
Control Message Protocol) messages to be sent back to the host
that sent the message.
Control Message Protocol) messages to be sent back to the host
that sent the message.
Proxy ARP Enable — Check this box to enable proxy ARP function.
Click the Apply button to save your changes or click the Cancel
button to discard your changes.
button to discard your changes.
5.2
Wireless Settings
The Wireless Settings page allows you to enable and configure
wireless connections.
wireless connections.
Basic Setting
The Basic Settings page allows you to enable the wireless function
of your Modem Router and set its SSID.
of your Modem Router and set its SSID.
To access the Basics Settings page, click SETUP > Wireless
Settings > Basic Setting or click the Wireless Setting button.
Settings > Basic Setting or click the Wireless Setting button.
Device — Check this box to enable the wireless function of your
Modem Router.
Modem Router.
SSID – Enter the service set identifier (SSID) or the name of your
wireless network. The SSID is case-sensitive and must not exceed
32 alphanumeric characters.
wireless network. The SSID is case-sensitive and must not exceed
32 alphanumeric characters.
BSSID — (Basic Service Set Identifier) Displays the MAC address of
your Modem Router.
your Modem Router.
Wireless Channel — Select the appropriate channel that corresponds
to your network settings. You should assign different channels for
each access point to avoid signal interference.
to your network settings. You should assign different channels for
each access point to avoid signal interference.
✌
TIP: Select Auto for Wireless Channel to allow your Modem
Router to select the best possible channel for your wireless
Router to select the best possible channel for your wireless