Adtran 1700412E11 ユーザーズマニュアル
NetVanta 150 Wireless Access Point ABG Hardware Installation Guide
Unit Installation
61700412E1-34A
Copyright © 2006 ADTRAN, Inc.
23
Wall Mounting
Figure 3. Wall Mounting the NetVanta 150 Unit
Instructions for Wall Mounting
Step
Action
1
Decide on a location for the NetVanta 150 unit. Keep in mind that the unit needs to be mounted
at or below eye-level so that the LEDs are viewable.
at or below eye-level so that the LEDs are viewable.
2
Prepare the mounting surface by attaching a board (typically plywood, 3/ 4-inch to 1-inch thick)
to a wall stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not
provide sufficient long-term stability.
to a wall stud.
Important! Mounting to a stud ensures stability. Using sheetrock anchors may not
provide sufficient long-term stability.
3
Install two #8 PAN headscrews (1 1/ 2-inch or greater in length) wood screws into the mounted
board, following these guidelines and referring to Figure 3:
board, following these guidelines and referring to Figure 3:
•
Screws should be spaced horizontally, approximately 5 inches apart. Find exact positioning
by using the location of the two keyed insets on the bottom of the NetVanta 300 Series unit
as a guide.
by using the location of the two keyed insets on the bottom of the NetVanta 300 Series unit
as a guide.
•
Screws should be horizontally level with each other.
•
Leave approximately 1/4 inch of the screws protruding from the board to allow the heads of
the screws to slide into place in the unit’s keyed insets.
the screws to slide into place in the unit’s keyed insets.
4
Slide the keyed insets on the bottom of the unit’s chassis securely onto the screws.
5
Proceed to the steps given in Getting Started on page 24.
STAT
WAN
DBU
TD