Adtran TRC6410L2X ユーザーズマニュアル
Section 5 User Interface Guide
TRACER 6000 Series Integrated System Manual
84
Copyright © 2005 ADTRAN, Inc.
612806420L1-1D
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> SNMP G
ET
C
OMMUNITY
Defines the community name for Get access (to poll the TRACER 64x0 for status information). This value
must match the Get name defined on the network management stations (NMS). Get access is read only
access. The default name is public.
must match the Get name defined on the network management stations (NMS). Get access is read only
access. The default name is public.
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> SNMP P
UT
C
OMMUNITY
Defines the community name for Set access (to change TRACER 64x0 configuration parameters through
SNMP). This value must match the Get or Set name defined on the NMS. The default name is private.
SNMP). This value must match the Get or Set name defined on the NMS. The default name is private.
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> SNMP T
RAP
C
OMMUNITY
Defines the community name for trap destinations. This name must match the community name defined on
the NMS. The default name is SNMP_trap.
the NMS. The default name is SNMP_trap.
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> SNMP T
RAP
H
OST
#0 - #4
Identifies the IP address in dotted decimal notation of the NMS for the TRACER 64x0 to send SNMP traps
to. Up to five trap destinations can be entered.
to. Up to five trap destinations can be entered.
> P
ING
U
TILITY
Figure 32 shows the Ping Utility menu page, which contains the parameters for performing a ping test out
of the 10/100BaseT/TX
of the 10/100BaseT/TX
MGMT
Ethernet interface.
Figure 32. Ping Utility
> P
ING
U
TILITY
> P
ING
A
DDRESS
Specifies the IP address to ping (in dotted decimal notation).