Unitech Electronics Co. Ltd. MS840BC ユーザーズマニュアル
6
To charge the scanner without a cradle, follow the instructions below:
1. Plug the AC adapter cable into the power
1. Plug the AC adapter cable into the power
socket of the foot of scanner.
2. Plug the AC adapter cord into an electrical
outlet.
Now, check whether the scanner LED will
be bright in solid red during charging.
When the charging is done, the scanner
LED will turn off.
be bright in solid red during charging.
When the charging is done, the scanner
LED will turn off.
Connection of a Scanner through a Cradle to a PC
Serial Port Profile (SPP)
In order to establish a proper connection between your computer and a scanner
through a cradle, we suggest that you follow these step-by-step instructions:
1. Determine to supply AC power to the cradle.
2. Turn on your computer.
3. Connect the cradle to the USB, RS232, or PS2 port of your computer
through a cradle, we suggest that you follow these step-by-step instructions:
1. Determine to supply AC power to the cradle.
2. Turn on your computer.
3. Connect the cradle to the USB, RS232, or PS2 port of your computer
respectively with a USB cable, RS232 cable, or PS2 cable.
4. Determine that the power LED on the cradle is bright in solid green and the
communication status LED on the cradle is bright in solid blue.
5. By default, the MS840 operates in SPP. Thus, by using at most 3 scanners,
scan the HOST ADDRESS barcode on the bottom side of the cradle.
6. The scanner LED should turn off and beep shortly one time with a high tone and
the communication status LED on the cradle should flash in blue.
※
In SPP mode, the cradle is set for functions necessarily through SCM.
The configuration of connection between your PC and the scanner through the
The Host Address barcode is on the bottom side of the cradle.