Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Management
Tsunami
®
800 & 8000 Series - Software Management Guide
213
To save the configured parameters, click OK and then COMMIT.
6.5 Access Control
The Access Control tab enables you to control the device management access through specified host(s). You can specify a
maximum of five hosts to control device management access.
maximum of five hosts to control device management access.
To configure management access control parameters, navigate to MANAGEMENT > Access Control. The Management
Access Control screen appears:
Access Control screen appears:
Time Zone
Configure the time zone from the available list. This configured time zone is considered
before setting the time, received from the time servers, on the device.
before setting the time, received from the time servers, on the device.
Day Light Saving Time
Configure the Day Light Saving time from the available list. This configured Day Light
Saving time is considered before setting the time, received from the time servers, on the
device.
Saving time is considered before setting the time, received from the time servers, on the
device.
ReSync Interval
Set ReSync time interval ranging from 0 to 1440 minutes. Once the time is synchronized,
the SNTP Client tries to resynchronize with the time servers after every set time interval.
the SNTP Client tries to resynchronize with the time servers after every set time interval.
By default, the ReSync interval is set to 60 minutes.
Sync Status
Specifies the SNTP Client sync status when it tries to ReSync again with the time servers.
The status is as follows:
The status is as follows:
•
Disabled: The SNTP client will not synchronize the time with the time servers and
displays the status as Disabled.
displays the status as Disabled.
•
Synchronizing: The SNTP client is in the process of synchronzing time with the time
servers.
servers.
•
Synchronized: The SNTP client has synchronized time with the time servers.
Current Date/Time
Displays the current date and time.
If SNTP is enabled, it displays the time the device received from the SNTP server. If SNTP is
not enabled, then it displays the time manually set by the user.
not enabled, then it displays the time manually set by the user.
Manual Time
Configuration
Configuration
If SNTP Client is disabled on the device or the time servers are not available on the
network, then the user can manually set the time. Enter the time manually in the format:
MM-DD-YYYY HH:MM:SS.
network, then the user can manually set the time. Enter the time manually in the format:
MM-DD-YYYY HH:MM:SS.
:
•
Manual time configuration is not retained across reboots. After every reboot
the user has to set the time again.
the user has to set the time again.
•
Over a period of time, with manual time configuration, the device may lag
behind the actual time. So, it is recommended to periodically check and adjust
the time.
behind the actual time. So, it is recommended to periodically check and adjust
the time.
Parameter
Description