Proxim Wireless Corporation XB92WFR ユーザーズマニュアル

–

The LED behavior in RSSI Display mode is given below: 

•

By default all the 5 LEDs will blink for an interval of 1 second to indicate the device is UP.

•

For a BSU, in order to monitor the SU link statistics, the user should first configure the wireless MAC address of the
SU. If the configured SU is registered with the BSU, then the LEDs will glow based on the RSSI value else all the 5
LEDs will blink.

•

For a SU, if the SU is registered with the BSU, then the LEDs will glow based on the RSSI value else all the 5 LEDs
will blink.

•

For a CPE, if the CPE is registered with the BSU, then the LEDs will glow based on the RSSI value else all the 5 LEDs
will blink.

•

For QB, if EndPointA is registered with EndPointB, then the LEDs will glow based on the RSSI value of each
EndPoint. else all the 5 LEDs will blink.

If Sync mode is enabled, the third LED behavior of the scaling mask will indicate the Sync status. 

To view the Sync status, navigate to Monitor > System. The LED/RSSI Display screen appears as shown below.

–

The LED behavior in Sync mode is described and tabulated below.

Interface Statistics allows you to monitor the status and performance of the Ethernet and Wireless interfaces of the device.

To view the Ethernet interface statistics, click MONITOR > Interface Statistics. The Interface Statistics screen appears:

OFF (Grey)

Synchronous mode is disabled or the device is out of Sync

Blinking (Green-Fast)

Synchronous mode is enabled, but Sync signal is not received

ON (Solid-Green)

Synchronous mode is enabled and Sync signal is received