Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Troubleshooting
Tsunami
®
800 & 8000 Series - Software Management Guide
274
8.7 Wired (Ethernet) Interface Validation
In order to optimize the network performance, apply QoS.
Given below is an example on how the network performance can be improved by applying
QoS. QoS is applied for SU1 with the following configuration:
Given below is an example on how the network performance can be improved by applying
QoS. QoS is applied for SU1 with the following configuration:
•
PIR based on the ToS value 96
•
SFC with MIR/CIR= 1Mbps; Priority = 3; Latency/Jitter=10ms
Subscribers SU2...SU5 use the default QoS configuration.
: Given above is just an example and values might vary from case-to-case.
Problem
Solution
Wired (Ethernet)
Interface Validation
Interface Validation
Run iperf commands
•
Use iperf commands with –w option as 202k. The throughput is expected to be
equal in both directions and should be comparable from laptop to laptop or desktop
to desktop performance
equal in both directions and should be comparable from laptop to laptop or desktop
to desktop performance
If the above throughput value is not in the expected range,
•
Check speed and duplex settings between the device and Personal Computer or
switch or router connected
switch or router connected
•
Make sure the connection established is of same speed and full duplex is as expected
(10 or 100 or 1000)
(10 or 100 or 1000)
•
With auto negotiation, if you notice this issue, then try manually setting the speed
and duplex
and duplex
•
Update the Ethernet driver in the Personal Computer to the latest one
Reason(s)
Observation
SU Profile(s)
Data Rate
Throughput
SU1
6.5 Mbps
Aggregated
throughput can be a
maximum of 13 Mbps
throughput can be a
maximum of 13 Mbps
SU2
39 Mbps
SU3
78 Mbps
SU4
130 Mbps
SU5
78 Mbps
Profiles
Data Rate
Throughput
SU1
6.5 Mbps
With QoS applied for
SU1, expected
throughput is 26 Mbps
SU1, expected
throughput is 26 Mbps
SU2
39 Mbps
SU3
78 Mbps
SU4
130 Mbps
SU5
78 Mbps