Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide
48
5.1 System
The System tab enables to configure system specific information.
To configure system specific parameters, navigate to ADVANCED CONFIGURATION > System. The System screen appears:
Figure 5-1 System Configuration
Given below is the table which explains System parameters and the method to configure the configurable parameter(s):
Parameter
Description
Radio Mode
Represents the radio mode of the device. Based on the SKU, the radio mode is set to either
BSU, SU, End Point A or End Point B.
BSU, SU, End Point A or End Point B.
In a BSU device, the radio mode can be changed from BSU to SU and vice versa. Also, in an End
Point A device, the radio mode can be changed from End Point A to End Point B and vice versa.
But note that a change in radio mode will reset wireless and WORP parameters of the device
after reboot.
Point A device, the radio mode can be changed from End Point A to End Point B and vice versa.
But note that a change in radio mode will reset wireless and WORP parameters of the device
after reboot.
Frequency Domain
A valid frequency domain must be set before the device can be configured with any other
parameters. Selecting a frequency domain makes the device compliant with the allowed
frequency bands and channels for that regulatory domain. See
parameters. Selecting a frequency domain makes the device compliant with the allowed
frequency bands and channels for that regulatory domain. See
Network Mode
The device can be configured in two network modes: Bridge and Routing. By default, the
network mode is Bridge mode.
network mode is Bridge mode.