Worthdata Inc LZ400RF ユーザーズマニュアル
10
The important thing to remember about using a laser with the RF
Laser Reader Setup Menu is that you need to make sure the
scanner's beam covers only one bar code at a time. The laser
scanner's beam is wide enough, and the configuration bar codes
close together enough, that you will need to use your fingers, or
the supplied Laser Setup Assist window, to "block off" bar codes
adjacent to whatever configuration bar code you need to read.
Laser Reader Setup Menu is that you need to make sure the
scanner's beam covers only one bar code at a time. The laser
scanner's beam is wide enough, and the configuration bar codes
close together enough, that you will need to use your fingers, or
the supplied Laser Setup Assist window, to "block off" bar codes
adjacent to whatever configuration bar code you need to read.
For example, to read
this "5" bar code on the
Setup Menu, you would
need to cover any
adjacent bar codes with
paper or a finger first,
as shown.
Don't forget to take the R/F Laser Scanner of Setup Mode by scanning End
Setup, otherwise the batteries will run down totally because the radio
transmitter remains on.
Setup, otherwise the batteries will run down totally because the radio
transmitter remains on.
Using The RF Laser Setup Menu
1. To configure your reader using the Reader Setup Menu, you must first
scan the Start Setup code at the top left corner. Do this now. You'll hear
two beeps. During Setup, nothing will be transmitted to your computer;
the Reader Setup Menu codes are strictly for configuring the reader. If you
did not hear two beeps, try scanning the code again, until you hear the two
beeps. If you've never scanned bar codes before, read the scanning
instructions on page 9 before continuing.
two beeps. During Setup, nothing will be transmitted to your computer;
the Reader Setup Menu codes are strictly for configuring the reader. If you
did not hear two beeps, try scanning the code again, until you hear the two
beeps. If you've never scanned bar codes before, read the scanning
instructions on page 9 before continuing.
2. Next, choose the topic you want to change an option for, and scan its
code. Let's use Beep Tone, at the lower left corner of the menu, as an
example. Scan the Beep Tone code now. You'll hear two beeps.
example. Scan the Beep Tone code now. You'll hear two beeps.
3. Then, choose the option you want to change, from the list next to the topic
bar code you just scanned. For Beep Tone, the options range from 0 for
the lowest pitch to 4 for the highest pitch. Using the "Barpad Table" on
the right side of the Reader Setup Menu, scan the number or letter
associated with the option you have selected. Let's change the beep pitch
to Highest.
the lowest pitch to 4 for the highest pitch. Using the "Barpad Table" on
the right side of the Reader Setup Menu, scan the number or letter
associated with the option you have selected. Let's change the beep pitch
to Highest.
4. Now
scan
End Setup (at the top-right corner of the Reader Setup Menu to
complete the setup exercise. You'll hear three beeps,. If you followed the
instructions correctly and successfully changed beep tone to "highest", the
instructions correctly and successfully changed beep tone to "highest", the