Worthdata Inc LZ400RF ユーザーズマニュアル

Configuring the RF Laser Reader
for your computer and application

Find the 8 1/2 x 11" laminated RF Laser Reader Setup
Menu sheet and look it over. This simple menu lets you
easily configure the Radio/Freedom Reader to work with
almost any computer system, and to tailor its bar code
reading and data format characteristics.

Be sure to read the scanning instructions on the next
page. To read Reader Setup Menu bar codes and
configure your reader, you must know the right way to

scan bar codes.

These are the RF Laser Reader's default settings and are shipped configured to
these settings; they can be reset to them at any time by scanning the Start
Setup and Reset codes on the Reader Setup Menu.

Code 39

UPC\EAN

• Enabled

• Check digit disabled

• UPC supplements disabled

• Accumulate Mode enabled

• UPC-E Compressed / NSC of 0

• Caps Lock Off

• UPC-A NSC and EAN-13 1st 2
characters

• Start/stop characters not transmitted

and check digits transmitted

2 of 5 Code

• UPC-E NSC and EAN-8 1st 2 characters

• Disabled

& check digits not transmitted

• I 2 of 5 Code Disabled

General configuration settings

• 6-digit code length

• Check digit disabled

• Channel 0

Code 128

• CR for Terminator Character

• Enabled

• Data Transmission Timing of None

• UCC/EAN-128 options disabled

• Medium Beep pitch

Codabar

• No preamble or postamble

• Disabled

• CLSI Format disabled

• USA keyboard

• Start/stop characters not transmitted

• 9600 Baud Rate, None Parity

MSI/Plessey

• 8 Data Bits, 1 Stop Bit

• Disabled

• Full Duplex Transmission

• Check digit(s) not transmitted

• ID=0

Code 93

• Disabled

• Full ASCII disabled

Be certain to turn off any bases with common frequencies before setting
up. If you need to change any of the default settings, or would like to learn
more about the Wireless scanner options, the next several pages will explain,
step by step, how to set them and