Hughes Network Systems 24SX-001 ユーザーズマニュアル
1027144– 0001 Revision D
5–10 Installing mast mounts
RT installation
5.
Lay out the 4 x 4s, as shown in figure 5-9, so that each
piece is:
piece is:
- In the recessed portion of the roof
- Parallel to the raised seams
- Equally spaced to support the mast, mount braces and
sides, and concrete blocks, as shown in figure 5-9.
Lay the lumber with the pad side down, so that the pad is
between the roof and the lumber.
between the roof and the lumber.
Figure 5-9
Supporting the mount on a corrugated aluminum roof
Mast
Roof
Cinder block
(ballast)
Cinder
block
block
Roof
Detail
Rubber pad
(strip)
Wood
(4x4)
Wood
(4x4)
Mast mount
(assembled from kit)
(assembled from kit)
Mast
mount
mount
Lag bolt
hb008
Nail
End view
6.
Follow steps 1 through 10 starting on page 5–4 to
assemble the mount.
assemble the mount.
Assemble the mount on the 4 x 4s so that when completed,
the mount is elevated above the aluminum roof.
the mount is elevated above the aluminum roof.
7.
Make sure the mount is evenly positioned on the 4 x 4s,
then use lag bolts to bolt the mount to the 4 x 4s.
then use lag bolts to bolt the mount to the 4 x 4s.
Install the bolts through the holes in the mount’s outer
frame and into the wood. Use one bolt at each end of each
piece of lumber (as shown in figure 5-9). Use one bolt at the
center of each remaining side of the mount.
frame and into the wood. Use one bolt at each end of each
piece of lumber (as shown in figure 5-9). Use one bolt at the
center of each remaining side of the mount.
8.
Add the required number of concrete blocks for ballast. See
steps 8 and 9 on page 5–8.
steps 8 and 9 on page 5–8.