Giant Electronics Ltd 2G4DSS24NS3 ユーザーズマニュアル
60
OLYMPIA OL2410 Owner's Manual
9.4.1 Normal state
1)
If in Toll Saver mode, the unit will answer after 4 rings when there is no
new message in the memory. Or after 2 rings when new ICM/MEMO is in
the memory.
new message in the memory. Or after 2 rings when new ICM/MEMO is in
the memory.
2)
If the number of ringer is setting 2, the unit will answer after 2 rings.
3)
If the number of ringer is setting 4, the unit will answer after 4 rings.
4)
The announcement 1 can heard from the caller line. (If you did not record
announcement 1, the default announcement 1 can be heard)
announcement 1, the default announcement 1 can be heard)
5)
After announcement playback, a beep is heard and starts incoming message
recording.
recording.
6)
If you want to select one mailbox among the three, you must press ‘ *1’ or
‘*2’ or ‘ *3 ’to select before the announcement is over, the DAM will
announce “mailbox * now recording” and followed by a beep, it indicate the
recording begin.
‘*2’ or ‘ *3 ’to select before the announcement is over, the DAM will
announce “mailbox * now recording” and followed by a beep, it indicate the
recording begin.
7) If you no press ‘ *1’ or ‘*2’ or ‘ *3 ’to select before the announcement is over,
a beep is heard and the messages will be recorded in mailbox1.
8) The LED will display “- - ” while recording.
9) The max length for each message is 1 minute, if the recording length is more
9) The max length for each message is 1 minute, if the recording length is more
than 1 minute, it will be stopped automatically, and a beep can be heard.
10) During ICM recording, if send 8 seconds of silence to the line, the DAM will
release the line.
11) During ICM recording, if send 8 seconds of busy tone to the line, the DAM
will release the line.
12) During ICM recording, if send 8 seconds of continuous tone to the line, the
DAM will release the line.
13) Recording will be stopped when memory is full. And three beeps are heard
together with voice prompt “memory is full”, the line will be disconnected.
14) Maximum number of messages is 50 (including ICM, & MEMO).
9.4.2 Branch phone detection
1) When in coming call and the DAM answer on, during OGM playback or ICM
recording, if press Handset PHONE key or pickup the parallel phone to take
the line, the unit should stop ICM recording within 5 seconds and go to
communicate with caller. The recorded message is invalid.
the line, the unit should stop ICM recording within 5 seconds and go to
communicate with caller. The recorded message is invalid.
2) During Remote Control State, if press Handset PHONE key or pickup the
parallel phone to take the line, the unit should exit remote control within 5
seconds.
seconds.
PDF created with FinePrint pdfFactory trial version