Giant Electronics Ltd 2G4DSSL2400 ユーザーズマニュアル
10
OLYMPIA OL24
0
0 Owner's Manual
3 Installation and Charging of the Battery Pack
Open the battery compartment by sliding the cover down.
Plug the Battery Pack connector into the Handset battery socket. Place the battery pack and wires in the compartment.
Close the battery compartment.
Mount the belt clip and one of the provided face panels on the Handset.
Plug the Battery Pack connector into the Handset battery socket. Place the battery pack and wires in the compartment.
Close the battery compartment.
Mount the belt clip and one of the provided face panels on the Handset.
Choose the appropriate mounting bracket. The smaller bracket is for desk or countertop installations. The larger bracket is
for wall mounting. You must use one of these brackets. Thread the telephone cord and DC power cord through the large
opening in the bracket. Plug the two cords into the corresponding jacks on the bottom of the Base.
Snap the bracket into place on the back of the Base. If you are using the desk top bracket, run the two cords through the
channel at the back of the bracket. If you are wall mounting the Base, carefully line up the slots on the wall mount bracket
with the studs on the telephone wall plate, and carefully mount the telephone on the wall.
for wall mounting. You must use one of these brackets. Thread the telephone cord and DC power cord through the large
opening in the bracket. Plug the two cords into the corresponding jacks on the bottom of the Base.
Snap the bracket into place on the back of the Base. If you are using the desk top bracket, run the two cords through the
channel at the back of the bracket. If you are wall mounting the Base, carefully line up the slots on the wall mount bracket
with the studs on the telephone wall plate, and carefully mount the telephone on the wall.
Connect the telephone line cord to the telephone jack, and the power supply to a live power outlet. Make sure you are not
using an outlet controlled by a switch.
using an outlet controlled by a switch.
Place the Handset in the Base. The Handset and Base communicate with each other automatically. This process may take a
minute.
Leave the Handset in the Base for 10 hours so that the battery pack is fully charged.
The CHARGE indicator on the Base glows when the Handset is charging.
minute.
Leave the Handset in the Base for 10 hours so that the battery pack is fully charged.
The CHARGE indicator on the Base glows when the Handset is charging.