CALAMP WIRELESS NETWORKS INC. 1409123000 ユーザーズマニュアル
CONFIGURATION
001-9193-001 Version 2
Page 41 of 52
Sentry 4G
TM
User
Manual
5.7.3.1.1 Example of Remote Login
The following should be entered into a browser on a remote PC to remote login to the Sentry 4G.
The Sentry 4G unit must have remote administration enabled for this functionality to work.
http://
70.209.115.93
:
8080
Figure 23 - Example of Remote Login
5.7.4
General Settings-Power Management
The Sentry 4G unit is designed to stay ON even if the ignition is turned OFF. You can configure your
Sentry 4G unit to automatically shut down 1, 5, 30, or 60 minutes after ignition is turned off or when
Sentry 4G unit to automatically shut down 1, 5, 30, or 60 minutes after ignition is turned off or when
the supply voltage drops to a certain level.
Shutdown Method: Disabled by default (unit always ON after ignition is turned OFF). Select
“Power Off” to enable power management.
“Power Off” to enable power management.
After ignition line off: Select between the following time intervals: 1 minute, 5 minutes, 30
minutes, or 60 minutes.
When Voltage Drops to: Enter desired voltage. Enter “0” to disable. (Note: A value of 11V would
be usually entered here as a precaution in order to ensure the car battery does not drain.)
minutes, or 60 minutes.
When Voltage Drops to: Enter desired voltage. Enter “0” to disable. (Note: A value of 11V would
be usually entered here as a precaution in order to ensure the car battery does not drain.)
Figure 24 - Power Management
“
WWAN IP Address"
On Unit Status page
"Configuration Port" on
"Remote Administation"
page.
"Remote Administation"
page.
Note: “HTTP” must be
specified or browser will
assume other uses
specified or browser will
assume other uses