Visonic Inc. MKP150 ユーザーズマニュアル
DE2462U
3
9
VAC
Wiring
Channels
Connect the 9 VAC
power supply to the
terminal block. Route
the wiring through the
wiring channels.
Note: The power
supply is optional
Figure 6: Wiring
4. ENROLLING/DELETING THE MKP-150 FROM THE POWERMAX+ MEMORY
To enroll all the MKP-150 functions (for complete list see PowerMax+ Installer Guide), enter the PowerMax+ Installer Mode from the
PowerMax+ keypad, and proceed as shown in the following illustration.
PowerMax+ keypad, and proceed as shown in the following illustration.
Note: Refer to PowerMax+
Installer Guide for details on
performing a diagnostic test
OK
(First display is READY
or NOT READY)
READY 00:00
USER SETTINGS
NORMAL MODE
ENTER CODE
1. NEW INSTL CODE
2. ENROLLING
[installer code]
INSTALLER MODE
ENROL WL 2WAY KP
ENROLL WL DEVICE
ENROLLING TYPE
[MKP-150 No. 1 to 2]
(e.g. 2)
2way kp No :
2way kp No : 2
2way kp No : 2
2way kp No: 2
Enrolling a wireless
Keypad MKP-150
for next
enrolling action
<OFF> TO DELETE
press back
tamper
switch
once
(see Fig. 4)
TRANSMIT NOW
Deleting a wireless
Keypad MKP-150
2way kp No: 2
ENROLL KEYFOB
Black rectangle means
that the MKP-150 No. 2
is already enrolled.
AWAY
OK
NEXT
NEXT
NEXT
NEXT
OK
OK
OK
NEXT
OK
NEXT
NEXT
NEXT
ENROL WL 1WAY KP
NEXT
9. DIAGNOSTICS
NEXT
Figure 7: Enrolling / Deleting a MKP-150 Device from PowerMax+ Memory
5. DEFINING MKP-150 PARAMETERS
5.1 Installer Menu Functions
Important: All installer settings affect only the specific keypad on
which the settings were performed.
The Installer menu enables you to perform three separate
which the settings were performed.
The Installer menu enables you to perform three separate
functions, as follows:
SUPERVISION
The keypad transmits supervision reports periodically to the
PowerMax+.
The options are: 15 minutes, 1 hour and disable.
PIEZO BEEP
Here you determine whether warning beeps will sound or muted
SUPERVISION
The keypad transmits supervision reports periodically to the
PowerMax+.
The options are: 15 minutes, 1 hour and disable.
PIEZO BEEP
Here you determine whether warning beeps will sound or muted
during exit and entry delays.
Options: enable beeps, off when home and disable beeps.
Options: enable beeps, off when home and disable beeps.
RECORD SPEECH
This mode allows you to record up to 5 custom zone names.
SERIAL NUMBER
Enables reading the system serial number for support purposes
only.
This mode allows you to record up to 5 custom zone names.
SERIAL NUMBER
Enables reading the system serial number for support purposes
only.
5.1.1 To Set Supervision Time
Make sure the system is not in Arm mode.
The installer’s menu is accessible only to those who know the
installer’s code, which is 9
The installer’s menu is accessible only to those who know the
installer’s code, which is 9
Î9Î9Î9 by factory default.
A. Press the next button (
►) repeatedly until the display reads:
I N S T A L L E R M O D E