HM Electronics Inc BS500 ユーザーズマニュアル

 

14

•  will be played to the locations selected if S8 switches 2, 

3 and/or 4 are in the ON position. 

        Switch 2 enables Message #2 to be played back in 
all HS500 headsets. 
        Switch 3 enables Message #2 to be played back on 
the outside speaker. 
        Switch 4 enables Message #2 to be played back on 
the ceiling speakers. 

station has lost and regained power, any message to the 
outside speaker will always be heard in the headset the first 
three times it plays. 

 

•  When adjusting microphone position, hold boom at base, not at 

microphone end. 

•  Carry headset by headband, not by earpiece or battery end, and 

never by microphone boom. 

•  Use both hands to put headset on or take it off. 

•  Remove batteries from headsets. 
•  Clean batteries and headsets with damp sponge sprayed with 

household cleaner.  Squeeze excess liquid out of sponge 
before using it. 

•  Clean metal contacts on batteries and headsets as follows.  

Wet tip of swab with alcohol and squeeze excess alcohol 
from it.  Wipe each contact with swab and be certain all 

contacts are dry before reinstalling batteries in headsets. 

•  Foam muffs on headset earpieces can easily be replaced for 

sanitary purposes.  To order extra foam muffs, call your 
local HME sales representative. 

Avoid splashing water or grease on the battery charger.  Clean 
the battery charger monthly as follows. 

CAUTION:  Always unplug the battery charger before cleaning 
it. 
•  Remove all batteries from the battery charger. 
•  Clean the battery charger case with a damp sponge.  Wet the 

sponge and wring it out so it is damp, not dripping wet.  
Spray household cleaner on the sponge (NOT DIRECTLY ON THE 
EQUIPMENT).  Clean the battery charger with the sponge and 
dry it thoroughly.