Westell Inc. A9080YYXX-07 ユーザーズマニュアル
UltraLine II – Draft 1
030-300459 Rev. A
7/12/05
030-300459 Rev. A
61
July 2005
User Guide
UltraLine II (Model 800015)
Metric
The numeric value assigned to this route, used to calculate the best route to a destination
network.
network.
Inactive Routes
The list of routes whose interface is currently not in service.
Address
Address
The IP address of the destination network.
Netmask
The subnet mask of the destination network.
Gateway
The IP address of the default gateway for this route.
Interface
The name of the router’s interface associated with this route.
Type
Indicates if this route is a network route, a host route, or a default route.
Metric
The numeric value assigned to this route used to calculate the best route to a destination
network.
network.
The following sections allow you to add static routes to the gateway’s routing table.
Route Via
Allows you to specify either the interface or the default gateway that the router should use for this static route. If an
interface is not specified, the correct interface will be automatically chosen, based on the gateway addresses.
Interface
interface is not specified, the correct interface will be automatically chosen, based on the gateway addresses.
Interface
Select the interface that will be used for this static route. If you enter an interface, you cannot
specify a default gateway.
specify a default gateway.
IP Gateway
Enter the IP address of the default gateway used for this static route. The specified gateway
must be reachable; this means that the Modem must have a route to the gateway. You must
specify either an interface or a gateway for each static route.
must be reachable; this means that the Modem must have a route to the gateway. You must
specify either an interface or a gateway for each static route.
Destination
Allows you to specify the destination network or host.
Type
Type
Factory Default = Host
Possible Responses:
Host – The static route is assigned to a single IP host.
Network – The static route is assigned to a network.
Default – The static route is assigned to a default route.
Possible Responses:
Host – The static route is assigned to a single IP host.
Network – The static route is assigned to a network.
Default – The static route is assigned to a default route.
IP Address
The IP subnet of the destination network or host.
IP Netmask
The subnet mask of the destination network. If the route type was a host, a 32-bit subnet
mask will be automatically populated.
mask will be automatically populated.
Metric
The numeric value assigned to this route, used to calculate the best route to a destination
network.
network.
RIP Advertised
This determines whether or not to advertise the static route using RIP. (RIP must also be
enabled before the route will be advertised.)
If Enabled (box is checked), RIP Advertised will be activated.
If Disabled, RIP Advertised will not be activated.
enabled before the route will be advertised.)
If Enabled (box is checked), RIP Advertised will be activated.
If Disabled, RIP Advertised will not be activated.
Save to Flash
If Enabled (box is checked), the route will be made permanent by saving it to flash memory.
If Disabled, the route will disappear the next time the Modem restarts.
If Disabled, the route will disappear the next time the Modem restarts.
Add Route
This button enables you to add a new static route in the Modem. Note: When adding a route,
you may need to reload the page for the route to appear in the “active” Routes.
you may need to reload the page for the route to appear in the “active” Routes.
15.10 Wireless Configuration
15.10.1 Basic
The following settings will be displayed if you select Wireless > Basic from the Configuration menu. Enter the
appropriate values, and then click Save to save your settings.