Westell Inc. A9081XXYY-07 ユーザーズマニュアル

 

 

 

 

 

030-300479 Rev. A 

50 

October 2005 

 User Guide 

by the network and which portion is controlled by the host. 

Address Range 
DHCP Start Address 

Displays the first IP address that the Public LAN DHCP Server will provide. 
The DHCP Start Address must be within the IP address and lower than the 
DHCP End Address. 

DHCP End Address 

Displays the last IP address that the Public LAN DHCP Server will provide. 
The DHCP End Address must be within the IP address and higher than the 
DHCP Start Address. 

DHCP Lease Time 

Factory Default = 01:00:00:00  
Displays the amount of time the provided addresses will be valid, after which 
time the Public LAN DHCP client will usually re-submit a request. 
Note: DHCP Lease Time is displayed in the format (day:hour:min:sec)*. This 
value must be greater than 10 seconds. Seconds must be between 0 and 59, 
minutes must be between 0 and 59, and hours must be between 0 and 23. 

 
 
If the settings you have entered in the Public LAN Settings fields are incorrect, the following warnings messages 
may be displayed via pop-up screens. If this occurs, check the Public LAN settings. 
 

Start Address is not part of the Subnet 

Check the value in the DHCP Start Address field 

End Address is not part of the Subnet 

Check the value in the DHCP End Address field 

End Address is below the Start Address 

Check the value in the DHCP End Address field 

Lease time must be greater than 10 seconds 

Check the values in the DHCP Lease Time fields 

Seconds must be between 0 and 59 

Check the Seconds field at DHCP Lease Time 

Minutes must be between 0 and 59 

Check the Minutes field at DHCP Lease Time 

Hours must be between 0 and 23 

Check the Hours field at DHCP Lease Time 

 
 

 
The following screen will be displayed if you select LAN > IP Passthrough from the Configuration menu. IP 
Passthrough enables you to select the device on your LAN that will share your Single Static IP address. Before you 
begin this section, configure your PC settings to obtain an IP address from your Gateway automatically. (Refer to 
your computer’s Windows® Help screen for instructions.) 
 
NOTE: IP Passthrough enables you to share the WAN-assigned IP address with one device on your LAN. Network 
Address Translation (NAT) and Firewall rules do not apply to the device configured for IP Passthrough. Thus, the 
device with the single static IP address becomes visible on the Internet. If you are using Routed IP protocol, IP 
Passthrough configuration will not be available.