Conifer Corporation 2278 ユーザーズマニュアル
6. Mount the complete unit on a
1-2” O.D. mast or on Conifer’s
optional DS-1000 mount assembly.
(See Figure 3.)
1-2” O.D. mast or on Conifer’s
optional DS-1000 mount assembly.
(See Figure 3.)
7. Connect the downlead cable to the
input/output on the Transverter.
(See Figure 4.)
input/output on the Transverter.
(See Figure 4.)
8. Run the downlead to the PS-0200
power supply connector labeled
“To Ant”. (See Figure 5.)
power supply connector labeled
“To Ant”. (See Figure 5.)
9. Run a cable from the PS-0200
power supply connector labeled
“To Set” to the set-top. (See
Figure 5.)
power supply connector labeled
“To Set” to the set-top. (See
Figure 5.)
5. Slide the mounting brackets and “L” Bolts into the bracket
channels on the backside of the Transverter. (See Figure 2.)
channels on the backside of the Transverter. (See Figure 2.)
Mounting
Bracket
“L” Bolt
Figure 2
Input/Output
-20dB Test
Figure 3
0-20 dB
Attn.
Downstream
To “Ant”
To “Set”
Figure 5
Bracket
Chan-
nels
DS-1000 Mount
Figure 4
Page 4.
Figure 3
4. Place the “L” bracket on the back of the antenna.
Insert two carriage bolts from the front (figure 4)
to attach. Secure on the back with the lock
washers and nuts. (See Figure 5).
to attach. Secure on the back with the lock
washers and nuts. (See Figure 5).
5.
Re-check the dipole feed assembly for the proper polarity.
(See Figures 1 & 2).
(See Figures 1 & 2).
Figure 4
Sub-reflector
Page 9.