Conifer Corporation 2278 ユーザーズマニュアル
Mast Clamp
U-Bolt
Figure 6
“L” Bracket
Lock Washers & Nuts
Figure 5
Figure 4
Tilt Holes
Tilt Slot
3. Place the "L" bracket on the back of
the antenna. Secure the feed on the
front with two carriage bolts. Secure
the feed on the back with the lock
washers and nuts. (See Figure 4).
front with two carriage bolts. Secure
the feed on the back with the lock
washers and nuts. (See Figure 4).
4. Place the mast clamp on the U-bolt.
(See Figure 6.) Fasten the U-bolt on
the “L” bracket with 2 lockwashers
and nuts. (See Figure 5).
the “L” bracket with 2 lockwashers
and nuts. (See Figure 5).
Note:
Fixed tilt holes provide
antenna elevation up to
60
antenna elevation up to
60
0
in 10
0
increments.
(See Figure 6).
Use the flat plate washer
on the adjustable tilt slot to
secure the antenna to the
required elevation.
(See Figure 7)
on the adjustable tilt slot to
secure the antenna to the
required elevation.
(See Figure 7)
Tilt Slot
Figure 7
5. Connect the GPS Antenna to
the GPS port on the
Transverter. (See Figure 8)
Transverter. (See Figure 8)
6. Connect the 18T-2127
antenna output to the an-
tenna port on the side of the
Transverter. (See Figure 8)
tenna port on the side of the
Transverter. (See Figure 8)
7. Mount the Transverter on the
mast by sliding the mounting
brackets and “L” Bolts into
the bracket channels on the
backside of the Transverter.
brackets and “L” Bolts into
the bracket channels on the
backside of the Transverter.
(See Figure 10.)
Page 6.
GPS Antenna
GPS Port
Antenna Port
(located on side
of transverter)
(located on side
of transverter)
Mounting
Bracket
“L” Bolt
Figure 10
Bracket
Chan-
nels
Input/Output
-20dB Test
Figure 9
0-20 dB
Attn.
Downstream
To “Ant”
To “Set”
Figure 11
Figure 8
8. Connect the downlead cable to the
input/output on the Transverter.
(See Figure 9.)
input/output on the Transverter.
(See Figure 9.)
9. Run the downlead to the PS-0200
power supply connector labeled
“To Ant”. (See Figure 11.)
power supply connector labeled
“To Ant”. (See Figure 11.)
10. Run a cable from the PS-0200
power supply connector labeled
“To Set” to the set-top. (See
Figure 11.)
power supply connector labeled
“To Set” to the set-top. (See
Figure 11.)
Page 7.