Laird Controls North America Inc. MKU915A ユーザーズマニュアル
Part # 68C-MKU, Edition 01/2007, Version 1.0
Page 35
NOTES: A system STOP may be initiated at any time during the control function
by pushing the red STOP switch downwards. It should be further
noted that in “pitch and catch” control operations where two OCUs are
used, only the OCU that sets the ‘STOP’ condition will re-set the ‘RUN’
condition.
noted that in “pitch and catch” control operations where two OCUs are
used, only the OCU that sets the ‘STOP’ condition will re-set the ‘RUN’
condition.
When all control functions have been completed, we recommend you
initiate a system STOP (push red STOP switch down) before setting the
ON/OFF switch to the ‘OFF’ position.
initiate a system STOP (push red STOP switch down) before setting the
ON/OFF switch to the ‘OFF’ position.
5.
Alternative Power-up procedure using bottom row keypad switches:
Referring to Figure 15 overleaf:
a. Press the ‘ON’ keypad pushbutton once and observe the multicolor STATUS
LED illuminates red.
b.
Press the ‘STOP’ keypad pushbutton once (1st & 2nd step) and observe the
multicolor STATUS LED illuminates orange.
multicolor STATUS LED illuminates orange.
c. Press the ‘ON’ keypad pushbutton once again and observe the multicolor
STATUS LED illuminates green..
NOTE:
The above Power-up sequence must be completed within 10 seconds.
WARNING:
BEFORE ATTEMPTING TO USE THE REMOTE CONTROL SYSTEM, VERIFY THE
TARGET CRANE OR MACHINE YOU WISH TO OPERATE IS UNDER THE DIRECT
COMMAND OF YOUR OCU. THIS IS ACCOMPLISHED BY OPERATING A NON-
MOTION OCU FUNCTION SUCH AS A HORN OR LAMP AND OBSERVING THAT
THE RESPECTIVE FUNCTION ON THE TARGETED CRANE OR MACHINE
RESPONDS.
TARGET CRANE OR MACHINE YOU WISH TO OPERATE IS UNDER THE DIRECT
COMMAND OF YOUR OCU. THIS IS ACCOMPLISHED BY OPERATING A NON-
MOTION OCU FUNCTION SUCH AS A HORN OR LAMP AND OBSERVING THAT
THE RESPECTIVE FUNCTION ON THE TARGETED CRANE OR MACHINE
RESPONDS.
FAILURE TO IMPLEMENT THE ABOVE MAY RESULT IN PERSONAL INJURY OR
DEATH TO PERSONNEL AND DAMAGE TO EQUIPMENT.
DEATH TO PERSONNEL AND DAMAGE TO EQUIPMENT.
6.
Press a non-motion Function Key (pushbutton) such as a horn or lamp and
observe that the targeted crane or machine responds. The MKU controller is now
fully operational and transmitting a signal as indicated by the multicolor STATUS
LED flashing green. Operate the keypad control and auxiliary pushbuttons as
required, remembering that each pushbutton must be maintained in order for the
function to continue to operate. Any or all functions may be operated simultaneously
if the controlled machine permits such operation.
observe that the targeted crane or machine responds. The MKU controller is now
fully operational and transmitting a signal as indicated by the multicolor STATUS
LED flashing green. Operate the keypad control and auxiliary pushbuttons as
required, remembering that each pushbutton must be maintained in order for the
function to continue to operate. Any or all functions may be operated simultaneously
if the controlled machine permits such operation.