Moseley Associates Inc 08MUD1F ユーザーズマニュアル

2-5  

Status Monitor Program 

 

602-13729-01 Rev B 

 

Expedio Digital Electronic News Gathering Radio 

To begin communicating with the Expedio unit, the Communications Settings must be properly 
configured. 

 

• 

In the Comm Port field, select the Comm Port to which the Serial Cable to the Expedio 
unit is connected. 

• 

In the Baud Rate field, select the Baud Rate as configured on the Expedio unit. For more 
information about configuring the baud rate, see the section of this manual regarding 
hardware setup. 

• 

Optional: Check Status on Startup automatically causes the Status Monitor Program to 
begin monitoring the Expedio unit each time the program is launched.  

Click OK to accept these communication settings. 

Note:   The Communications Settings cannot be changed while Status Checking is started. To 

change Communications Setting, ensure that Status Checking is stopped. 

The behavior of the Expedio unit depends on its MPEG Configuration. The appropriate 
configuration depends upon the system itself, so Expedio comes equipped with three preinstalled 
configurations to choose from. Any of these can serve as the default configuration, which is the 
configuration that the Expedio will run whenever it is started or reset. 

With administrative privileges, it is possible to modify the three preinstalled configurations. This 
can only be done with the assistance of Moseley Technical Support personnel. 

1.  In the Configuration Number field, enter the number of the desired configuration. For a 

complete description of the factory installed configurations, see Default MPEG 
Configuration Settings.  

2. Click 

Switch Config.  

3.  A confirmation screen appears. If you are sure you want to change configurations, click 

OK.