Nikko Co Ltd RP7370H ユーザーズマニュアル
- 1 -
1/14 RADIO CONTROL TRUCK
Owner's Manual
•
2 channel Full Function
--- Runs forward, backward, turns left & right and stops.
•
3 Band Selector Switch.
•
Oversized Off-Road tires.
•
Impact resistant bumper.
FEATURES
- 3 -
- 2 -
1. HOW TO ATTACH ANTENNA TUBE
PREPARATION FOR STARTING OPERATION
Pass the antenna wire through the antenna tube,
then insert the tube into the antenna tube holder.
If the antenna tube cannot be successfully inserted
into the antenna tube holder, try holding the root of
the antenna wire with fingers of one hand and ex-
tending the wire with fingers of the other hand.
2. HOW TO INSTALL THE BATTERY
To remove the battery lid, press the point
marked “OPEN” and pull the lid downward.
Transmitter
Vehicle
When installing a Ni-Cd battery pack,
make sure that the power switch of the vehicle is OFF.
* Do not charge Battery Pack immediately after use. Wait until it is cooled before charging.
* Avoid short circuits. Short circuits will cause overheating, burning of the cords and other
* Avoid short circuits. Short circuits will cause overheating, burning of the cords and other
damages to the Battery Pack and Charger.
* The Ni-Cd Battery Charger should be used for charging one Battery Pack. Do not use the
* The Ni-Cd Battery Charger should be used for charging one Battery Pack. Do not use the
charger for charging other types of batteries and battery packs.
* Do not use the Charger as a direct current outlet for other electrical appliances or
* Do not use the Charger as a direct current outlet for other electrical appliances or
machines.
* Make sure that the Battery Pack and Charger are kept out of the hands of infants and small
* Make sure that the Battery Pack and Charger are kept out of the hands of infants and small
children while charging.
* Do not charge near fires, where the temperature is extremely high, or where it is wet or
* Do not charge near fires, where the temperature is extremely high, or where it is wet or
damp.
* The charger will become slightly heated while charging. Allow sufficient free space around
* The charger will become slightly heated while charging. Allow sufficient free space around
the Charger.
* If the power of the battery pack is weak in spite of proper charging. The batteries may be
* If the power of the battery pack is weak in spite of proper charging. The batteries may be
worn out from repeated use. Replace it with a new Ni-Cd battery pack.
* Dispose of use Ni-Cd battery packs correctly.
* Disconnect the supply before making or breaking connections to the battery.
* Only use batteries or accumulators of the recommended type or a similar type.
* WARNING AGAINST RECHARGING NON-RECHARGEABLE BATTERIES.
* Please use this battery charger only for the charge of the rechargeable battery pack.
* The Ni-Cd battery pack should be recharged under the supervision of an adult.
* This power unit is intended to be correctly orientated in a vertical or floor mount position.
* Dispose of use Ni-Cd battery packs correctly.
* Disconnect the supply before making or breaking connections to the battery.
* Only use batteries or accumulators of the recommended type or a similar type.
* WARNING AGAINST RECHARGING NON-RECHARGEABLE BATTERIES.
* Please use this battery charger only for the charge of the rechargeable battery pack.
* The Ni-Cd battery pack should be recharged under the supervision of an adult.
* This power unit is intended to be correctly orientated in a vertical or floor mount position.
Check the batteries regularly for leakage.
Remove empty batteries from the toy.
Never try to charge non-rechargeable batteries.
Rechargeable batteries may only be charge under the supervision of an adult.
When inserting the batteries take care not to reverse their polarity.
Never use batteries of different manufacturers, and do not mix old and new batteries.
Use only the recommended batteries or batteries of equal quality.
Never short-circuit the terminals.
Removable batteries which can be recharged must be removed from the toy prior to
Remove empty batteries from the toy.
Never try to charge non-rechargeable batteries.
Rechargeable batteries may only be charge under the supervision of an adult.
When inserting the batteries take care not to reverse their polarity.
Never use batteries of different manufacturers, and do not mix old and new batteries.
Use only the recommended batteries or batteries of equal quality.
Never short-circuit the terminals.
Removable batteries which can be recharged must be removed from the toy prior to
charging.
CAUTION :
CAUTION :
NOT RECOMMENDED FOR CHIL-
DREN UNDER 8 YEARS OF AGE.
AS WITH ALL ELECTRIC PROD-
UCTS, PRECAUTIONS SHOULD BE
OBSERVED DURING HANDLING
AND USE TO PREVENT ELECTRIC
SHOCK.
INPUT: 120VAC, 60HZ,
OUTPUT: 7.25VDC, 180mA
ATTENTION PARENTS
It is recommended that this toy
and all accessories be periodically
examined for potential hazards and
that any potential hazardous parts
be repaired or replaced.
CAUTION: ELECTRIC TOY
BATTERY REQUIREMENTS
Vehicle: Ni-Cd battery energy
pack (6.0V, 600-800mAh)
Transmitter: 1x9V(006P) battery
Repair and Parts Department
Monday to Friday 8:30AM-5:30PM Central Time
Repair :(800)736-4556
Parts :(800)776-4556
Fax
:(972)578-7059
e-mail :help@nikkoamerica.com
* Recharge the Battery
Before You
Start to Operate
PRINTED IN CHINA
© NIKKO
BATTERY CHARACTERISTICS AND RECHARGING TIPS
BATTERY CHARACTERISTICS AND RECHARGING TIPS
When playing for the first time after purchase, or after a long interval, the battery power may
be weak. Even after recharging, the playing time can be relatively short. The battery will
gradually regain power after 2 or 3 repetitions of usage and recharging.
Install the Ni-Cd battery pack into the battery compartment of the battery charger.
Plug the charger into an ordinary household outlet.
Plug the charger into an ordinary household outlet.
* The (LED) light on charger should light up when the battery pack is being charged.
* Average recharging time is approximately 4 to 5 hours.
* Average recharging time is approximately 4 to 5 hours.
When the recharging is over, remove the charger from the household outlet.
Push the lever of battery charger and disconnect the battery pack from the battery charger.
Push the lever of battery charger and disconnect the battery pack from the battery charger.
“WARNING! USE UNDER THE DIRECT SUPERVISION OF AN ADULT.”
* The newly purchased Ni-Cd pack is not charged. Recharge before operate.
1
Battery charger
2
3
4
1
2
2
3
4
4
Battery pack
Household outlet
Push the level
HOW TO RECHARGE
*
Please read carefully before starting to operate.
*
Keep the display box and the manual for future reference.
*
WARNING! Use under the direct supervision of an adult.
*
Actual product may vary from illustration of this manual.
Antenna
tube holder
Antenna wire
Antenna Tube
Use a coin to turn the battery stopper to the
“OPEN” position.
Install the Ni-Cd battery pack into the
Install the Ni-Cd battery pack into the
battery compartment of the vehicle.
Replace the battery stopper.
Replace the battery stopper.
1
2
3
* Note: Be careful not to pull antenna wire too strong.
1
Battery stopper
2
3
Power switch
OPEN
One 9 volt (006P) battery
Install battery making sure that (+) and (-) poles
are positioned properly.
* Dispose the used battery separately from other trash.
CAUTION:
*
Install battery make sure that (+) and (-)
poles are positioned properly.
Ni-Cd battery
energy pack (6.0V)