Computime Limited RCSIT-TX ユーザーズマニュアル
50D0098 RCSITE Installation & Operating Manual
Rel 0 Dec 2005
Rel 0 Dec 2005
Page 4 of 10
Ambient Technologies
A Division Of Monessen Hearth Systems
Back of the Transmitter
Battery
Door
Tab
Remote Transmitter
:
Installing Batteries:
The remote transmitter uses three (3) “AAA” batteries.
To install batteries,
1. Press down the battery door tab and pull out to remove the battery door.
2. Install the batteries as indicated on transmitter.
3. Close the battery door by snapping in place.
4. When three batteries are installed, the transmitter will initialize for 10
2. Install the batteries as indicated on transmitter.
3. Close the battery door by snapping in place.
4. When three batteries are installed, the transmitter will initialize for 10
seconds and then is ready for use.
5. The batteries should be replaced at least once every 6 months or when the
low battery icon indicator is displayed.
Setting Privacy (DIP) Switch on Receiver and Transmitter:
The remote receiver and transmitter privacy (DIP) switches are preset at the factory. In the event of activation or
interference from other nearby transmissions, reset the code using the following procedure:
1. Slide the code switches on the transmitter and receiver to your choice of ON or OFF position. Switches
#1, #2, #3 and #4 are preset to “ON” for both the transmitter and receiver.
2. The switches on the transmitter and receiver must match in order for the system to work.
3. To check, press either the On or Off button on the transmitter and the receiver indicator light will blink. If
not repeat step 2.
4. The system is now ready to operate.
#1, #2, #3 and #4 are preset to “ON” for both the transmitter and receiver.
2. The switches on the transmitter and receiver must match in order for the system to work.
3. To check, press either the On or Off button on the transmitter and the receiver indicator light will blink. If
not repeat step 2.
4. The system is now ready to operate.
NOTE See optional 6 hour shutdown on page 8 of 10.
ON
DIP
ON
DIP
Receiver
Dip Switch (Default)
Transmitter