RELM Communications Inc SRU50ABC ユーザーズマニュアル
S Series Repeater USER MANUAL
©RELM Communications Inc. Revision 1.0
12
Side view SR35/50
MOUNTING HOLES FOR SLIDE-OUT RAILS
THE HEATSINK AIRFLOW EXITS SIDEWAYS SO ANY NUMBER OF SR35/50
CAN BE STACKED IN A RACK ONE ABOVE THE OTHER
CAN BE STACKED IN A RACK ONE ABOVE THE OTHER
Installation
WARNING: Ensure that all safety precautions are observed when working with electrical
and electronic equipment. Please contact RELM Communications if you
are in any doubt about the suitability of your test environment.
are in any doubt about the suitability of your test environment.
SR35/50 series radio systems are securely packed for transport in polystyrene foam peanuts, within a pasteboard
container. Before unpacking the SR35/50 radio, please inspect the packaging for signs of damage and report any
damage to your SR35/50 distributor.
container. Before unpacking the SR35/50 radio, please inspect the packaging for signs of damage and report any
damage to your SR35/50 distributor.
Upon unpacking of the SR35/50 radio, please ensure that all items shipped were received, report any missing items
to your SR35/50 distributor. All ports on the rear of the radio should be carefully examined to ensure that packaging
has not become wedged inside them. It is very important to examine the fan as operation of the radio will be effected
if any packaging causes the fan to stop working.
to your SR35/50 distributor. All ports on the rear of the radio should be carefully examined to ensure that packaging
has not become wedged inside them. It is very important to examine the fan as operation of the radio will be effected
if any packaging causes the fan to stop working.
If you intend to install the radio in an equipment rack, consult the installation manual for your system. RELM
Communications recommends that the radio is secured into the rack system using four screws through the mounting
holes in the front panel, near the handles.
Communications recommends that the radio is secured into the rack system using four screws through the mounting
holes in the front panel, near the handles.
If the radio is to be used in a stand alone configuration, ensure that it is in a secure,
dry location with sufficient air space around it to allow for adequate ventilation.
dry location with sufficient air space around it to allow for adequate ventilation.