Futaba Corporation CGY760R-24G ユーザーズマニュアル

Select "Cond #" in the same way and use the [

/

+] or [

/

-] key to set the via trainer channel of the transmitter.

The transmitter’s trainer channel uses two consecu-
tive channels. For example, if CH11 is set to "# 1", 
CH12 is automatically set to "# 2". Therefore, when 
using this function, two consecutive free channels are 
required for the transmitter.

This resets the S.BUS channel assignments back to 
the defaults. Move the cursor to "RESET" by press-
ing the [

/

+] or [

/

-] key, and press the [Enter] key to 

enter the reset mode. Since "EXECUTE: Enter (1sec)" 
is displayed, press and hold the [Enter] key for about 
1 second to initialize S.BUS channel setting. If you do 
not reset, press [Enter] key or [Esc/Page] key to exit 
reset mode.

With this function, by connecting the transmitter and the GPB-1 with the trans-
mitter connection cord, it is possible to wirelessly change the setting of the CGY 
760R mounted on the model via the transmitter. For the list of functions that can be 
changed, refer to pages 106 to 107. Before connecting the GPB-1 to the transmitter, 
please connect to the CGY 760R and save the original data to GPB-1.

1.  Follow the transmitter’s instruction manual, use the channel function function to con-

nect two consecutive AUX 2.

2.  Set the two free channels to the following settings.

Sub Trim:  ---------------------------------- 0
Fail safe:  ------------------------------- hold
Battery fail safe:  ---------------------OFF
Set the end point:  --------------------100
The limit point:  --------155 (maximum)
Servo speed:  ----------------------------- 0
Servo Reverse:  ------------------ Normal 

3.  Set the trainer function as follows according to the transmitter’s instruction manual.

Always ON
Teacher / Student:  ------------- Teacher
Channel mode:  -------------------- 16CH
Mode:  ------------------------------ Normal
Rate:  ------------------------------------100

After connecting the GPB-1 to the TX via trainer port, power on the TX. Upon turning 
the TX 

"On" the GPB-1 will show the opening screen and the ID screen will be displayed. 

The ID number should be the same as the ID sticker on the CGY760R. If the ID numbers 
match, press and hold the [Esc / Page] key to display the trainer via function setting screen.

Note: If the ID is different on the ID conirmation screen, connect CGY760R 
and GPB-1 that you set once and save the data of CGY760R to GPB-1.

Press and hold
the[Esc/Page] key

Press and hold
the[Esc/Page] key

Press and hold
the[Esc/Page] key

Press and hold
the[Eter] key

Press the [Enter] key 
with the cursor on the 
"Via Trainer"