Brother Industries Ltd. 8CAE19 ユーザーズマニュアル
136
Error messages
B
As with any sophisticated office product, errors may occur. If this happens, your machine identifies
the error and shows an error message. The most common error messages are shown below.
the error and shows an error message. The most common error messages are shown below.
You can correct most errors by yourself. If you need more help, the Brother Solutions Center offers
the latest FAQs and troubleshooting tips.
the latest FAQs and troubleshooting tips.
Visit us at http://solutions.brother.com.
Error Message
Cause
Action
Comm.Error
Poor telephone line quality
caused a communication error.
caused a communication error.
Send the fax again or connect the machine
to another telephone line. If the problem
continues, call the telephone company and
ask them to check your telephone line.
to another telephone line. If the problem
continues, call the telephone company and
ask them to check your telephone line.
Connection Fail
You tried to poll a fax machine
that is not in Polled Waiting mode.
that is not in Polled Waiting mode.
Check the other fax machine's polling
setup.
setup.
Cover is Open.
The scanner cover is not closed
completely.
completely.
Lift the scanner cover and then close it
again.
again.
The ink cartridge cover is not
completely closed.
completely closed.
Firmly close the ink cartridge cover until it
clicks.
clicks.
Data Remaining
Print data is left in the machine's
memory.
memory.
Re-start printing from your computer.
Print data is left in the machine's
memory. The USB cable was
unplugged while the computer
was sending the data to the
machine.
memory. The USB cable was
unplugged while the computer
was sending the data to the
machine.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
the job and clear it from the memory. Try to
print again.
Disconnected
The other person or other
person's fax machine stopped the
call.
person's fax machine stopped the
call.
Try to send or receive again.
Document Jam
The document was not inserted or
fed properly, or the document
scanned from the ADF was too
long.
fed properly, or the document
scanned from the ADF was too
long.
See Using the ADF on page 10.
See Document jam on page 141.
DR Mode in Use
The machine is set to Distinctive
Ring mode. You cannot change
the Receive Mode from Manual to
another mode.
Ring mode. You cannot change
the Receive Mode from Manual to
another mode.
Set Distinctive Ring to off. (See Turning off
Distinctive Ring on page 49.)
Distinctive Ring on page 49.)
High Temperature
The print head is too warm.
Allow the machine to cool down.
Hub is Unusable.
A Hub or USB Flash memory
drive with Hub has been
connected to the USB direct
interface.
drive with Hub has been
connected to the USB direct
interface.
A Hub or USB Flash memory drive with
Hub are not supported. Unplug the device
from the USB direct interface.
Hub are not supported. Unplug the device
from the USB direct interface.
Image Too Long.
The size of your photo is irregular
to add effects.
to add effects.
Choose a regular shaped image.
Image Too Small.
The size of your photo is too small
to trim.
to trim.
Choose a larger image.