Charm Engineering Co. Ltd CAI001-BT33 ユーザーズマニュアル
CORITICAL ACTIVITY INDEX
|
34
2.6 Use Environment
2.6.1 Storage
The monitor and other components can be shipped and stored under below conditions
Note: The following conditions are conditions for shipping and storage in state that the device
is not under operation.
Note: The following conditions are conditions for shipping and storage in state that the device
is not under operation.
•
Temperature 10 ℃ to 65 ℃
•
Humidity 30% to 95% (without condensation)
•
Atmospheric pressure 1060hPa to 700hPa
The CAI system and CAIs sensor should be protected from sudden temperature changes and
used after maintaining temperature and humidity similar to ordinary condition.
As adhesiveness of CAIs sensor may vary depending to seasonal changes, it is recommended to
store them in same temperature conditions.
Do not store them in any place with metal, magnets or place affected by magnetic power.
used after maintaining temperature and humidity similar to ordinary condition.
As adhesiveness of CAIs sensor may vary depending to seasonal changes, it is recommended to
store them in same temperature conditions.
Do not store them in any place with metal, magnets or place affected by magnetic power.
2.6.2 Use Environment of Device
CAI is not designed to be used in a place where flammable gas or steam exists. CAI is
designed to be used safely in below conditions.
In environment out of below conditions, reliability of device may be affected.
designed to be used safely in below conditions.
In environment out of below conditions, reliability of device may be affected.
•
Temperature 10 ℃ to 65 ℃
•
Humidity 30 % to 95 % (without condensation)
•
Atmospheric pressure 1060hPa to 700hPa
2.6.3 Electromagnetic compatibility (EMC) Conditions
CAI should use only a power supply (battery) supplied or recommended by Charm Engineering.
The device should be installed and used according to contents described in Chapter 5
“Electromagnetic compatibility guideline”.
※ Caution: CAI system is used according to IEC 60601-1-2 electromagnetic compatibility
requirements.
Using any devices within close distance from this device may give or receive effects from
electromagnetic interferences (EMI). If EMI occurs, refer to Chapter 5 “Electromagnetic
interference prevention”.
The device should be installed and used according to contents described in Chapter 5
“Electromagnetic compatibility guideline”.
※ Caution: CAI system is used according to IEC 60601-1-2 electromagnetic compatibility
requirements.
Using any devices within close distance from this device may give or receive effects from
electromagnetic interferences (EMI). If EMI occurs, refer to Chapter 5 “Electromagnetic
interference prevention”.
2.6.4 Preparation for use : Installation of monitor
In order to improve safety and convenience of using Charm Engineering devices, it is
recommended to install the CAI system to anesthetic device permanently. However when
permanent installation is difficult, it can be fixed with tongs.
recommended to install the CAI system to anesthetic device permanently. However when
permanent installation is difficult, it can be fixed with tongs.