LinkCom Manufacturing Co. Ltd. LCBTMD02 ユーザーズマニュアル
7
3：Contact information
Address： 5F., No. 127, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231, Taiwan
Phone：
Fax：
Website：
Email：
+886-2-8919-1380
+886-2-8919-1370
http://www.linkcom.com.tw
sales@linkcom.com.tw
ORIGINAL EQUIPMENT MANUFACTURER (OEM) NOTES
The OEM must certify the final end product to comply with unintentional radiators (FCC Sections 15.107 and 15.109)
before declaring compliance of the final product to Part 15 of the FCC rules and regulations. Integration into devices
that are directly or indirectly connected to AC lines must add with Class II Permissive Change.
The OEM must comply with the FCC labeling requirements. If the module’s label is not visible when installed, then an
additional permanent label must be applied on the outside of the finished product which states: “Contains transmitter
module FCC ID:
2AOC5LCBTMD02
”. Additionally, the following statement should be included on the label and in
the final product’s user manual: “This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interferences, and (2) this device must accept any
interference received, including interference that may cause undesired operation.”
The module is limited to installation in mobile or fixed applications. Separate approval is required for all other operating
configurations, including portable configuration with respect to Part 2.1093 and different antenna configurations.
A module or modules can only be used without additional authorizations if they have been tested and granted under
the same intended end
‐use operational conditions, including simultaneous transmission operations. When they have
not been tested and granted in this manner, additional testing and/or FCC application filing may be required. The most
straightforward approach to address additional testing conditions is to have the grantee responsible for the certification
of at least one of the modules submit a permissive change application. When having a module grantee file a
permissive change is not practical or feasible, the following guidance provides some additional options for host
manufacturers. Integrations using modules where additional testing and/or FCC application filing(s) may be required
are: (A) a module used in devices requiring additional RF exposure compliance information (e.g., MPE evaluation or
SAR testing); (B) limited and/or split modules not meeting all of the module requirements; and (C) simultaneous
transmissions for independent collocated transmitters not previously granted together.
This Module is full modular approval, it is limited to OEM installation ONLY.
Integration into devices that are directly or indirectly connected to AC lines must add with Class II Permissive Change.
(OEM) Integrator has to assure compliance of the entire end product include the integrated Module. Additional
measurements (15B) and/or equipment authorizations (e.g Verification) may need to be addressed depending on
co-location or simultaneous transmission issues if applicable.
(OEM) Integrator is reminded to assure that these installation instructions will not be made available to the end user of
the final host device.