Mobius Mobility LLC 22007 ユーザーズマニュアル
SECURING TO A VEHICLE
You can drive the device into a vehicle either by
sitting in the device using Standard or 4-Wheel
mode (depending on the degree of incline), or by
transferring out and using
sitting in the device using Standard or 4-Wheel
mode (depending on the degree of incline), or by
transferring out and using
Remote mode for
angles up to 20 degrees.
The ibot must only be transported in a vehicle
that is approved for such purposes.
that is approved for such purposes.
1. Check that the all components are secured
to or removed from the device.
2. The ibot must be locked into position by
running tie-down straps through the
securement points at the front and rear,
marked with the following hook labels:
securement points at the front and rear,
marked with the following hook labels:
3. Secure the device according to the
manufacturer of the vehicle restraint
systems instructions. Always make sure
that the fastening points on the transport
vehicle are well-anchored.
systems instructions. Always make sure
that the fastening points on the transport
vehicle are well-anchored.
4. Confirm the that the freewheel lever (brake
release) is in the locked position and the
device is powered off.
device is powered off.
5. Call Technical Support if you have
questions about securing the device in a
motor vehicle.
motor vehicle.
H
a
n
d
lin
g
124
DKPX-09006-001-Rev. 1.7