Mobius Mobility LLC 22007 ユーザーズマニュアル
4. Gently lift the battery from its connector and
slide it towards the back of the device to
remove.
remove.
Be careful not to damage the raised battery
connector on the device.
connector on the device.
5. Repeat
and
for the all other
batteries if required.
WARNING
Only remove a battery pack in environments that do not allow
water or other contaminants into the device or battery pack
through the connectors. This can cause shock hazards.
water or other contaminants into the device or battery pack
through the connectors. This can cause shock hazards.
Always ensure all battery connectors are covered by
manufacturer approved parts.
manufacturer approved parts.
INSTALL BATTERY PACKS
1. The device must be powered off and
unoccupied before installing the battery
packs.
packs.
2. Hold the back of the battery above the
power base battery connector and slide the
front nose into the front retainer.
front nose into the front retainer.
3. Line up the mounting hole and gently press
the battery pack onto its electrical
connection.
connection.
4. Install and tighten the fastener that holds
the back of the battery.
Be careful not to cross-thread.
5. Repeat for the other battery packs, if
required.
6. Fully charge the battery packs.
7. Power ON the device to verify operation.
M
a
in
te
n
a
n
c
e
142
DKPX-09006-001-Rev. 1.7