Mobius Mobility LLC 22007 ユーザーズマニュアル
M
a
in
te
n
a
n
c
e
Valve stem must be angled towards the
outside of the wheel and evenly seating the
tire around the rim.
outside of the wheel and evenly seating the
tire around the rim.
10. Place the plastic shield and then the inner
rim onto the back of the tire.
Make sure the cutout in the plastic shield
aligns with the valve stem and the foam
spacers are between the shield and the inner
rim.
aligns with the valve stem and the foam
spacers are between the shield and the inner
rim.
11. Secure the rims to each other using a torque
wrench (5-mm hex bit) and five new shorter
screws, tightening the screws in a star
pattern.
screws, tightening the screws in a star
pattern.
Tightening torque (star pattern): 133 in.-lbs.
(15 Nm).
(15 Nm).
CAUTION
Do not reuse fasteners. Replace any used fasteners with new
fasteners provided by the manufacturer.
fasteners provided by the manufacturer.
WARNING
Ensure all fasteners have been securely tightened prior to
putting the device back into service.
putting the device back into service.
12. Check that the tire is evenly seated around
the entire wheel and that it did not get
pinched between the rims.
pinched between the rims.
13. Inflate the tire to 55 psi (380 kPa).
14. Reinstall the valve stem cap.
15. Secure the wheel to the device using a
14. Reinstall the valve stem cap.
15. Secure the wheel to the device using a
torque wrench (5 mm hex bit) and five new
longer screws, tightening the screws in a
star pattern.
longer screws, tightening the screws in a
star pattern.
Tightening torque (star pattern): 177 in.-lbs.
(20 Nm).
(20 Nm).
Confirm the following:
1. Tire pressure inflated to 55 psi (380 kPa)
and is not leaking air.
2. All five screws holding the drive wheel to
device were installed with the correct torque
and in a star pattern.
and in a star pattern.
DKPX-09006-001-Rev. 1.7
167