Mobius Mobility LLC 22007 ユーザーズマニュアル
3. All five screws holding the rims together
were installed with the correct torque and in
a star pattern.
a star pattern.
Verify the replacement was done correctly by
performing the following performance checks:
performing the following performance checks:
1. With the device in
4-Wheel Mode, spin the
device in place one full revolution to the left,
then one full revolution to the right.
a. Ensure wheel does not show visible
then one full revolution to the right.
a. Ensure wheel does not show visible
wobble or make an audible rattling noise
while driving.
while driving.
2. With the device in
4-Wheel Mode, drive
around for a minute at varying speeds and
turning to both sides.
a. Ensure wheel does not show visible
turning to both sides.
a. Ensure wheel does not show visible
wobble or make an audible rattling noise
while driving.
while driving.
STORAGE
This section describes the procedure to use
when storing the device for several months.
when storing the device for several months.
•
Always store your ibot fully charged.
•
Confirm the device is powered OFF.
•
Store the ibot on a level surface in a clean,
dry place between 50 - 104 °F (10 - 40 °C).
dry place between 50 - 104 °F (10 - 40 °C).
•
Check batteries once a month and recharge
as needed.
as needed.
-
If you expect to store the ibot for more than
4 months, remove the batteries and store
them separately.
4 months, remove the batteries and store
them separately.
•
Do not store items on the ibot.
M
a
in
te
n
a
n
c
e
168
DKPX-09006-001-Rev. 1.7