WINLITE INTERNATIONAL LTD DIN1001 ユーザーズマニュアル
Remark: the LED on the bottom will turn red while the speaker is being charged,
and the LED light will be off after full charge.
** POWER ON/OFF
Turn on the D-IN BT Speaker by pressing the ON/OFF button located on the top of
the speaker. D IN is automatically in Bluetooth mode when it’s an ON mode, and the
Blue LED for Bluetooth will flash first and later keep on. Then the Bluetooth
module start working..
**Playing music via Bluetooth mode
1.Connect the speaker with the Bluetooth-enabled devices in the 1
st
time, the Blue
LED light will keep flashing for searching the BT signal.
If it’s not the 1
st
time for the speaker to work with Bluetooth-enabled devices, when
it’s on BT mode, the blue LED light will keep on in a few seconds after flashing, at
this moment the D-IN BT speaker is trying to connect the memorial
Bluetooth-enabled device. Once it’s done, the LED will flash slowly, but if it’s failed,
after 5 seconds the BT indicator will flash, waiting for the connection with new
device, then follow the steps as below
2. Ensure Bluetooth-enabled devices has Bluetooth switched on and begin searching
for devices, select the “
bluSound
” device and if a password is required
enter “
0000
”.When the blue LED flashes slowly, the pairing with Bluetooth-enabled
devices has been completed